Tuner
Banjo tuner
Play a string and see its note, how far flat or sharp it is, and which way to turn the peg. Or hear each string and tune by ear. Standard tuning is G D G B D, from string 5 to string 1.
Press Start tuning, then play one string
Input
A =440 Hz
Listening
The microphone is asked for only when you press Start, and heard only while the tuner is on. Nothing is recorded or sent.
How to tune a banjo
- Press Start tuning and allow the microphone when your browser asks. A quiet room helps.
- Play one string, open, and let it ring. The tuner names the note it hears and the string it is nearest.
- If the needle is left of the middle, the string is low (flat): tighten it. If it is right of the middle, it is high (sharp): loosen it. Turn a little at a time, and play the string again.
- When the needle sits in the middle and the note turns green, that string is in tune. Go on to the next.
- Tune each string up to its note rather than down to it: the string holds its tuning better. Check them all once more at the end, because tuning one pulls a little on the others.
No microphone? Click a string above to hear its note, tick Keep playing the string I click, and turn the peg until your string and the note sound the same, with no slow wobble between them.
A tuner for every banjo tuning
Double CG C G C DC tuning (drop C)G C G B DG modal (sawmill)G D G C DOpen DF♯ D F♯ A D